Steps for Adjusting the Tool Speed of Gear Shaper

Writer： admin Time：2024-05-15 13:55:58 Browse：67℃

1、 Steps for Adjusting the Tool Speed of Gear Shaper

The speed adjustment of the gear shaping machine tool is divided into two steps: pre adjustment and fine adjustment.

1. Pre adjustment

Firstly, it is necessary to find the appropriate work speed. Usually, simply set the motor speed to the maximum value and use a manual controller to control the cutting speed. After determining the appropriate working speed, fine adjustments can be made.

2. Fine tune

Rotate the fine-tuning knob upwards or downwards, gradually adjusting the working speed until the most suitable speed is found. At this point, the speed of the gear shaping machine tool has been adjusted. It should be noted that when adjusting the speed, do not be too impatient and gradually make slight adjustments

Can achieve the best effect.

2、 The impact of adjusting speed on tool quality and production efficiency

The adjustment of tool speed will have a direct impact on the quality and production efficiency of gear shaping machine cutting. If the speed is too slow, it will lead to insufficient gear insertion, substandard cutting product quality, and also affect production efficiency;

If the speed is too fast, it will accelerate tool wear, reduce cutting quality, and also increase the failure rate of the gear shaping machine. Therefore, adjusting the tool speed correctly can improve work efficiency and extend the service life of the tool.

In short, it is necessary to be patient and gradually perform pre adjustment and fine-tuning to adjust the speed of the gear shaping machine tool in order to achieve the best effect. The correct operating methods can not only improve work efficiency and prolong the service life of cutting tools, but also play an important role in cutting quality.